Truck wiring questions

[ScottAR]

The vehicle is a '99 F350 with original tow package. There's a factory square plug for the original tow package 7 wire RV plug (missing). Someone added a 7
wire plug in the bed for a gooseneck hitch. What I want to do is retain the bed 7wire, and add another 7wire to the bumper without cutting off the square plug.

Is there a factory adapter I can Tee out two 7 wire plugs or is surgery in order?

I should be able to figure this out but I'm stuck.

 

[davkir]

If I understand, you want to have both 7-pin plugs in the bed and on the bumper working.
They make a TEE connector that plugs into the truck harness and the existing bumper connector plugs into it. It comes with a pigtail that you can run to the bed. I think I've used ones from Hoppy or Pollak but any good trailer supplier should be able to get them.

 

[Diamondpilot]

Yes, Uhaul or any trailer hitch shop will have what you need that will go in with no cutting of the wires. I have even seen what you need at most large Super Wal Marts. That is if the previous owner did not butcher it.

Chris

 

[ScottAR]

Valley seems to make the one I need... Thanks guys...