TSC Carryall

[Benja]

Sorry if this post doesn't make sense, my wife is talking while I'm trying to type.

My recently purchased carryall has a one inch diam. hole for the top link and my Bota B2410 has a 3/4 diam hitch pin that snugly fits in the top link arm.

Is there an attachment needed to mate the two or is the 3/4 inch rod allowed to float inside the larger hole?

 

[gordon21]

It can float or you can buy some $1 bushings at TSC. That gives you an excuse to go back and some more goodies.

 

[greg_g]

My recently purchased carryall has a one inch diam. hole for the top link and my Bota B2410 has a 3/4 diam hitch pin that snugly fits in the top link arm.

I find it surprising that TSC would carry a Cat 2 carryall. Unless that hole was overbored by mistake, the lift pins should be too big for your little Kubota as well. Back to the top hole though - I would use bushings to avoid egging out the hole. But then maybe you don't carry the weight that I do on mine - which I got at Rural King by the way. It's got a 3/4" hole, so I don't need bushings.

Is there an attachment needed to mate the two or is the 3/4 inch rod allowed to float inside the larger hole?

If it's simply overbored by mistake, TSC won't likely have a bushing for that situation. What you could do though is find a short piece of 3/4" ID steel pipe. It will have a 1" OD. Cut a section of pipe that is long enough to go through both holes on the carryall, then slide your toplink pin through it.

//greg//

 

[Inspector507]

The red Carry All I purchased at TSC over 5 years ago also has a 1" hole for the top link. Hasn't bothered me a bit being a little sloppy. Makes it easier to hook it up