tuff stuff tubs

   / tuff stuff tubs #1  

rmankty

Bronze Member
Joined
Sep 28, 2011
Messages
59
Tractor
1948 farmall cub
Hello,anyone own a plastic or rubber tub,the large ones made by tuff stuff for feeder stock or mixing cement.Im wondering how they hold up.I understand you have to bring them in during the winters when below freezing.Any comments?
 
   / tuff stuff tubs #2  
I dont have one but a lot of people who do aquaponics use them.
 
   / tuff stuff tubs #3  
I have the 16" diameter round in both the plastic and rubber used for water in the dog kennel. Use them year round and only ones had broken were the plastic, but that is when someone uses a broom handle to bust the ice crust and hits bottom of the pan, cracks it. Other than that no problem.
 
   / tuff stuff tubs
  • Thread Starter
#4  
Thank you forgeblast, I am looking forward to getting a sunroom,and may use one of the big tanks for just that purpose.Do you actually do forging? Thanks!
 
Last edited:
   / tuff stuff tubs #5  
Not as much as I like to, but I am hoping once I finish my small propane forge to do a lot more. I have been doing a lot of woodcarving lately.
 
   / tuff stuff tubs
  • Thread Starter
#6  
I have the 16" diameter round in both the plastic and rubber used for water in the dog kennel. Use them year round and only ones had broken were the plastic, but that is when someone uses a broom handle to bust the ice crust and hits bottom of the pan, cracks it. Other than that no problem.

thank you for info SSdoxie. I am looking to get one for mixing cement with-I'll just clean it out good and keep it inside over winter!Thanks!
 
   / tuff stuff tubs
  • Thread Starter
#7  
Not as much as I like to, but I am hoping once I finish my small propane forge to do a lot more. I have been doing a lot of woodcarving lately.

I used to work as a lathe hand years ago.I am looking to buy some equipment for my home,and put it to use making money.Forging is something that is very interesting,I have thought about getting some equip-small equip to start with.Its fascinating to watch the hotmetal being formed,like watching metal come off a workpiece like butter.There must be a way to make money doing these things as a one man shop to start. Im looking for a niche.
 

Tractor & Equipment Auctions

Kewanee 15' Disk (A50515)
Kewanee 15' Disk...
2017 Nissan Maxima Sedan (A50324)
2017 Nissan Maxima...
2014 UTILITY 53X102 DRY VAN TRAILER (A51222)
2014 UTILITY...
2007 International 4300 DT466 Refer Truck (A47384)
2007 International...
2011 Cadillac SRX LUXURY (A50324)
2011 Cadillac SRX...
2019 CATERPILLAR 259D SKID STEER (A51242)
2019 CATERPILLAR...
 
Top