Bob Nelson
Bronze Member
- Joined
- Jan 31, 2019
- Messages
- 65
- Location
- Oakland, MI
- Tractor
- Branson 2400h, New Holland TC33d, Ford 1720, Kubota BX2350d
Hello everyone. Hope someone can help me.
I recently bought a TYM 233 with the T200 loader. Loader worked good except no float. I read the thread about removing the cap and cleaning it out. I did that and foolishly reversed them and broke the cap on the outer side. I fixed with JB weld and a large clamp. It looks like heck but it works as it did before.
Here are my questions:
1) Is just the cap repaceable?
2) I cleaned it out very good and seemed to move around in there but they both were very corroded and rusty. Will getting a replacement fix this issue or do I need to replace the valve body entirely?
3) If not repairable, is there anyway to replace the entire setup?
4) Any thoughts very welcome.
I have attached a photo of what the setup looks like. As you all know this is a cable acutated setup.
Thanks,
Bob Nelson
I recently bought a TYM 233 with the T200 loader. Loader worked good except no float. I read the thread about removing the cap and cleaning it out. I did that and foolishly reversed them and broke the cap on the outer side. I fixed with JB weld and a large clamp. It looks like heck but it works as it did before.
Here are my questions:
1) Is just the cap repaceable?
2) I cleaned it out very good and seemed to move around in there but they both were very corroded and rusty. Will getting a replacement fix this issue or do I need to replace the valve body entirely?
3) If not repairable, is there anyway to replace the entire setup?
4) Any thoughts very welcome.
I have attached a photo of what the setup looks like. As you all know this is a cable acutated setup.
Thanks,
Bob Nelson
