Posthole Digger U-joints for Ford Posthole digger

[scazmando]

Looking for u-joints for a Ford 22-08 post hole digger.
Can anyone help?

 

[Ultradog MN]

I looked at the CNH and can't find a model 22-08 anything.
Are you sure you have the numbers right?
Does the phd happen to look like the one in the picture?
If so it is a Ford 903 and the dealer does still support most parts on them.
Otherwise you could just take your old yokes to your nearest clutch and U joint shop and they can probably match them up.

 

[LD1]

I am sure your local auto parts store carries them, but the model number is probably not something they can look it up by.

Measure it. Diameter of all 4 caps, and length from cap to cap. Sometimes there are two different size caps and lengths to adapt to different size yokes.

Or just take one out and take to a parts store.

 

[scazmando]

Got the numbers wrong. I believe its a 22-63. Looks identical to the one in the pic.
Thanks for your help.

 

[Sysop]

Any driveshaft shop will have U-joints to fit any PTO shaft AFAIK...

 

[rksinc57]

I am interested in purchasing this 22-63 PHD from you. It is needed for testing. We can replace it with a newer one in proper condition. Please contact me at rksinc@mac.com

 

[rksinc57]

Can you send me close up pictures of the drive shaft guard at the gearbox with a tape measure in the photos? Also the Ford label showing model and serial number? Also some other photos from all angles. I notice that the lever for adjusting the angle of the auger is missing, but I may be interested in purchasing this auger assembly because it is needed for testing. We would of course replace it with a newer model in better shape, equipped with the PTO shield (not on this unit). Let me know. Thanks. rksinc@mac.com