V belt size????

[watersteps]

Hello,

I just purchased a David Bradley 917.575121 with a Wisconsin ACN engine. The tractor has 3 belts which I would like to replace at sometime. the belts are 530H, 529H and 7843MI per the manual. Can anyone tell me what size belts I need to replace these belts??

Thanks

 

[leonz]

Hello,

I just purchased a David Bradley 917.575121 with a Wisconsin ACN engine. The tractor has 3 belts which I would like to replace at sometime. the belts are 530H, 529H and 7843MI per the manual. Can anyone tell me what size belts I need to replace these belts??

Thanks

No worries,

All V belts are metric so its not a problem find a V belt reseller like NAPA that can measure the belts for you using a V belt gauge and they will provide you the proper new V belts quickly.:thumbsup::drool:

 

[watersteps]

The problem is the belt I have is a 1/2 inch belt this pulley takes a 5/8 belt.

I have been using it and it works fine but, I have decided to replace this Wisconsin ACN with a Briggs or Tecumseh with a recoil starter.

I will be selling the Wisconsin or trading it for a 8 hp Briggs if possible.

Thanks for the info.

 

[Craig Clayton]

On your V belt spend the extra money a get outdoor or equipment rated belts. They are meant to have a back idler so they bend and they are fabric covered. Industrial belts are meant to run inline and around larger sheaves.
Craig Clayton

 

[watersteps]

Thank you, good advice.