kdlklm
Silver Member
I took apart my grasshopper vac and the blades are quite bent, are they supposed to be perfectly 90ｰ or should they be on a slight angle.
Vac Blades Straight or angled?
- Thread starter kdlklm
- Start date
- Views: 787
Carl_NH
Elite Member
- Joined
- Apr 5, 2002
- Messages
- 3,833
- Location
- Coastal NH
- Tractor
- 01 Kubota B21TLB, 2010 Ferris 52" ZTR, Cub Cadet 1811, Gravely Super8
Take a picture - also is it not working properly? I have a trac vac and the impeller and blades (4) are pretty much on at 90* angles but if one is out "bent" you should be able to see that. I have stopped the motor on mine ingesting a chunk of wood and it didnt impact the blades at all - they are 1/4" thick steel.
