allen in texas
Platinum Member
- Joined
- Oct 26, 2007
- Messages
- 919
- Location
- Levelland, TX
- Tractor
- Kubota Grand L 5740, loaded R1's w/640 lbs cast weight, 854 loader
I built myself a chisel of sorts awhile back with 9 shanks and paddle points that cuts about 9 foot wide.This morning I changed out all the points to a sharp very curved chisel spike. The paddle points on the thing did an OK job but it wasn't the best and it was hard to pull. So after I got all the points changed out I was excited to see how it did so I went at the turn rows around my cotton field. I set it down and took off. Man it pulled better. I usually pulled it mid low at about 4 mph but it felt like it didn't even have a load on it so I clicked up into high and it the tractor topped out. MAN!! this is great. So I looked back to see if I was going to fast and low and behold, my chisel was still sitting at the end of the turnrow about 70 yards back. 
I had forgotten to latch the quick hitch. :confused2::shocked:
Oh well,
I backed up and rehooked and all is well. Thought y'all would get a kick out of this.
:laughing:
Oh well,
I backed up and rehooked and all is well. Thought y'all would get a kick out of this.
:laughing: