What are the ears called that cyl pins gothru

[Stargazer]

Hi:

Thinking about adding hyd angle to rear back blade (landpride 60"). What are the ears that the cly pins go thru called? Source for? Don't have 1" stock nor bit big enough make hole. Thought pre made and bolt on/clamp.

Thanx PR

 

[5030]

It's called a cylinder clevis. Try TSC.

 

[slowzuki]

I think he's talking about the tang rather than the clevis?

 

[J_J]

These are your different types.

Surplus Center - Tech Help

Click on hydraulics, then cyl ends.

 

[Leejohn]

He must be talking about the anchor end with a 1" hole and 1" thick.

 

[J_J]

Tabs, cyl mount, brackets, etc.

Hercules Sealing Products-Hydraulic cylinder repair seals and seal kits, replacement cylinders and cylinder components for construction and many other heavy equipment industries.

http://www.northerntool.com/shop/tools/product_620047_620047

http://www.peninsularcylinders.com/metrichydraulicaccessories.pdf

I have used a 3 in x 2 in tab, and bored a 3/4 or a 1 in hole for the pins.

If you use say 1/4 thick metal, you can bore the hole for a weld in bushing that will support the pin, or use say 3/8 to 1/2 in metal for the tabs/ears.

http://www.berrienbuggy.com/3099b8e0.jpg

I have also done a DXF drawing, and gave it to a place that did plasma cutting and had them cut about 20 of the tabs out of 3/8 steel.

 

[Stargazer]

Thanx JJ and all. The north tool link is what I am looking for guess also called tang. Least now got the term to look for.

PR