Quick Hitches What Implement(s) Would Fit this bill?

[lbaxterh]

Having recently upgraded from a JD 4400 to a 4066 I have gone from one rear SCV pair to now having five rear SCV pairs plus power beyond. Last night my friend was looking at the tractor and said "What implement could you ever have that would use five sets of SCVs?" In my case two of them are used for top/tilt which leaves 3 sets.... but I still wasn't able to give him a good answer. My snowblower requires two sets of SCVs for rotation of chute and angle of deflector. I'm sure on much larger tractors the implements like harrows need a lot. But does anyone have any good answer I can give him for an implement for a 66hp tractor that would require 3 sets of SCVs (since 2 are used by top/tilt)?

 

[dusty3030]

One run to the front to run the grapple - everyone should have a grapple. If one of your 5 is the electric with the thumb switch on the joy stick that is the one for the grapple.

2 for top and tilt.

Other two left could go on numerous things but stumpgrinder comes to mind - one swings other does up and down.

 

[dusty3030]

Spray rig - boom height is one, boom fold is the other.

 

[RedNeckRacin]

a full hydraulic rear blade. Offset, angle, and tilt.

 

[jeff9366]

Box Blade top, tilt and ripper extension/retraction.

 

[MtnViewRanch]

Top & tilt, a rear blade with angle, offset and tilt = 5 sets required. For larger blades, a set of gauge wheels, but that size blade would be to big for his tractor. I have come across a few guys that have needed 6 sets to be able to operate everything without connecting-disconnecting all the time.