What is your best modifacation ?

[mytonka]

Hi Guys new member here.
What is your best modification? This is Prime Creative & Bragging Time fellas. Show your best ideas.

 

[300UGUY]

Not a tractor mod, but putting the implements on dedicated dollies helps a lot. Especially the post hole digger or the rototiller.

 

[topbuilder]

When I made my tractor bumper, I used heavy wall rectangular pipe. It bolts to the tractor and the lid and bumper are connected and hinged so the bumper lays down to carry t-posts ect and then the inside carries tools, top-link and spare pins for different hook ups. Just enough room for a chainsaw and fuel can. Has worked for many different chores over the years. I'll have to see if I can get a pic loaded.

 

[dieselcrawler]

Post erased

Edit: I'm sorry, I didn't realize this was in the terramite section, I found the thread thru the 'today's posts' link... not a place to brag about my JD mods.

 

[mytonka]

please send pictures

 

[mytonka]

well send a picture. A good idea is a good idea

 

[ovrszd]

Post erased

Edit: I'm sorry, I didn't realize this was in the terramite section, I found the thread thru the 'today's posts' link... not a place to brag about my JD mods.

I did the same thing Greg but saw your post before I created one of my own.....

 

[dieselcrawler]

well send a picture. A good idea is a good idea

Are you asking for non-terramite pictures? Who you were asking wasn't clear. I will happily share, but don't wish to clog your thread unless that's what you are asking for...

I've used a terramite TLB a few times, stout little machines.

 

[mytonka]

Hi dieselcrawler & ovrszd
I do not want to clog the thread However if you have a good idea with a picture I would welcome that

 

[dieselcrawler]

I'll keep it simple...

Wheel spacers that fit between the outter rim and center dish. Gained 4.5" on each side.



Chain saw scabbard



Bucket extention to increase capacity, easily u-bolts in a few minutes.



Full cage ROPS/FOPS