Where to tie down my L4400 while hauling.
- Thread starter zkubota
- Start date
- Views: 1206
Danno1
Veteran Member
.
The four corners of the tractor and any implement. That means the FEL and whatever you have on the 3 point hitch. Total 6 tiedowns.
Some guys use straps, most use chains. Either must be rated and marked.
Opinions are strong; arguements get heated. Almost as much as fuel/tires/oil!
.
The four corners of the tractor and any implement. That means the FEL and whatever you have on the 3 point hitch. Total 6 tiedowns.
Some guys use straps, most use chains. Either must be rated and marked.
Opinions are strong; arguements get heated. Almost as much as fuel/tires/oil!
.
wushaw
Elite Member
3/8" Grade 70 chains and binders.
N80
Super Member
I'm no expert and likely did it wrong since I only used three points on my L4400. I ran chain around the axle housing on each side of the front and then ran one chain throught the draw bar bracket underneath the tractor and anchored each end to a corner of the trailer . Used ratchet chain binders.
Chains scratched the paint on the axle housings up front and now there's a little rust, but hey, its a tractor.
That's what I've done. Its worked each time. Never killed anybody. But that doesn't mean I did it right.
Chains scratched the paint on the axle housings up front and now there's a little rust, but hey, its a tractor.
That's what I've done. Its worked each time. Never killed anybody. But that doesn't mean I did it right.
