Woods RM990 belt broke removed alimites

[Fatdaddy]

I had a belt break Woods RM990 so I got a belt put it on and going to grease it.
Both alimites on both sides are GONE !!
I felt around for a hole where one went but did not find nothing.

ANYBODY got any ideals of pictures of what it looks like.
The middle Alimite is there.

 

[RickB]

Zerks on my RM990 extend directly towards the outside of the deck from under the pulleys. Exactly perpendicular to the direction of travel.

 

[Fatdaddy]

yea I know where the hole is to put grease in the bearings. Now there is NO Zerks [tks for the right word}

 

[zzvyb6]

When the belt started going Tango Uniform, the zerks may have been popped off, out, up and away.

 

[RickB]

yea I know where the hole is to put grease in the bearings. Now there is NO Zerks [tks for the right word}

Well you posted that you felt around for the hole but didn't find anything. Exactly what type of a response did you expect?

As suggested, the failing belt probably wiped them out. Now you get to remove the broken pieces from the spindle housings.

 

[Fatdaddy]

Well
As Now you get to remove the broken pieces from the spindle housings.

That is what Iam asking how do you do it?
I was expecting to find the holes where the Zeke went in to.

 

[RickB]

You need to use the proper size stud extractor to remove the piece of pipe nipple that is undoubtedly still in the housing. In all likelihood you will need to remove the pulley from the spindle, and probably remove the spindle from the mower deck itself to have access.