I've seen bits and pieces on the forum on these and different makes that the front axles leak at the breather and fill caps. I've been keeping it in the mid safe zone on the stick. Ours will do this intermittently. I can't hardly think that new caps will correct the problem. Am I wrong? Has anyone or their dealer tried a different viscosity fluid? :confused3:
XJ2025H Front axle leakage
- Thread starter tomplum
- Start date
- Views: 5878
George2615
Super Member
Oil level at the midway point is correct. Overfilling may or will cause a leak,
As for tire pressures, your owners manual has recommended pressures listed based on type of tires you have.
Mine, of course is a larger tractor with larger tires and calls for 50 PSI front, 20 PSI rear using R4's. I run 45-50 front and 16 rear in mine. Higher pressures in front for loader work. Lower in rear for better ground contact footprint.
As for tire pressures, your owners manual has recommended pressures listed based on type of tires you have.
Mine, of course is a larger tractor with larger tires and calls for 50 PSI front, 20 PSI rear using R4's. I run 45-50 front and 16 rear in mine. Higher pressures in front for loader work. Lower in rear for better ground contact footprint.
The pressures listed were what was listed in the manual. The loader manual states to use the max pressure. The fronts were 5#s off from one another , but the highest was 33 PSI. I don't recall what the tire said on the sidewall. I'll up the front pressure and experiment with the rear as well. She's been playing in the dirt with the loader, so I should up the pressure some.
