ScottAR
Veteran Member
I guess everything went to plan?
Hi Scott, yes, I just completed the first cylinder and all went fine. I'm now trying to remove the second cylinder which is the "level cylinder"' on the loader. I'm really not sure how this one works (what activates it). I don't really see a control handle for it. Anyway, removing this one is a pain. The pin had a bolt in it to keep it from coming out, The bolt was previously broken off so I've been grinding with a dremel tool and drilling and I'm optimistic but not there yet. Tommy
Scott, I'd like to bug you with a couple more questions and then I hope I'll be ready to "reassemble". 1) The way I understand what you have told me, the orientation of the inner and outer seals in attached photos are correct. Is that right? 2) Look closely at the inner seal shown in the photo. Did yours have a lip on the outside edge like the one shown? I kind of thought it would be flat like the inside of the gland where it is to go. Thanks again for all your input. Tommy