BHD
Veteran Member
I would with that mower, most likely flip it on it side and start to figure how to make a entire sub frame and attaché it in the front the middle an back to the rear axel, (my first thought would be to use 2 inch square tubing about 3/16 to 1/4 wall, two pieces on each side, then use some flat to reach up and bolt to the current frame may be a heavy angle across the front or a U shaped piece attach where the front axel goes, and then attached the front axel to that,
come out the about the middle with a channel or tube to attach the loader to, and some place in the front to mount some angle braces, possibly the front U shaped piece I said to mount to where the front axel mounts, extent it a little to bolt the angle braces on to the up rights,
come out the about the middle with a channel or tube to attach the loader to, and some place in the front to mount some angle braces, possibly the front U shaped piece I said to mount to where the front axel mounts, extent it a little to bolt the angle braces on to the up rights,