Recent content by 2345joes

  1. 2345joes

    Stanadyne injection pump drive shaft tool 13371

    Thanks! I think this is the weekend.
  2. 2345joes

    Stanadyne injection pump drive shaft tool 13371

    Thanks! Thought about texting. Anything else that is helpful to know for putting this pump back on? I have the flywheel pin tool and the umbrella seal tool.
  3. 2345joes

    Stanadyne injection pump drive shaft tool 13371

    Installing the roosa master injection pump back on the driveshaft after a rebuild. Anyone know how this tool is meant to be oriented? I'm thinking the beveled side with the notch goes facing the injection pump. Has anyone used one of these? Joe
  4. 2345joes

    Injection pump rebuild? Successively more common stallouts.

    I’ll give it another try this weekend. If so does this mean time for a rebuild?
  5. 2345joes

    Injection pump rebuild? Successively more common stallouts.

    At the end of the season last year the tractor would run strong for a while, but then loose power and stall out. It restarts right away, but within a few minutes looses power and stalls out again. It seems to run longer if it has been parked, with a shorter run time after every restart. There...
  6. 2345joes

    Injection pump rebuild? Successively more common stallouts.

    1973 820. Transfer pump looks rough, but seems to pump well. Cut off solenoid audibly engages with the switch.
  7. 2345joes

    John Deere 820 pitted hydraulic line

    Would one check by opening the drain plugs to see if there is water at the bottom of the case? The hydraulic fluid was changed spring 2021.
  8. 2345joes

    John Deere 820 pitted hydraulic line

    I was surprised that that the pitted line was the one with the leak (not the patched one). Is it typical to see this much foaming for a line leak?
  9. 2345joes

    Re Wiring main switch John Deere 820 (1973)

    A&I (Left) John Deere (Right). The center in positive and corresponds to terminal 30 in the wiring diagram.
  10. 2345joes

    Re Wiring main switch John Deere 820 (1973)

    Power is the middle terminal. I ordered the JD version with a key for around $70. I'll post a photo of it when I get it.
  11. 2345joes

    Re Wiring main switch John Deere 820 (1973)

    I have not looked, but maybe worth a call.
  12. 2345joes

    Re Wiring main switch John Deere 820 (1973)

    Hey everyone, First off the battery box and dash need some dusting. I'm trying my hand at electrical. The original switch was jumped to a toggle instead of ignition by the previous owner. I have a wiring diagram and a new A&I main ignition switch. The back of the replacement has numbering that...
  13. 2345joes

    180 F or 194 F thermostat? (JD 820)

    180 F or 194 F thermostat? Preventative maintenance on a 1973 JD 820. Western Oregon is a fairly temperate part of the world. I can't tell if there is much of a difference for one vs another. Any thoughts? AT22961 Remarks 180°F (82°C) AT22963 Remarks 194°F (90°C)
Top