Recent content by F2036

Well today I had a weak moment and bought a 1978 B7100 TLB . It stared kind of hard, #2 fuel and the temps in the 20's . It has a little over 1300 hours on the meter, and needs a little TLC. Nothing serious, replace some cyl seals and maybe a hose here and there, steering is tight, tires are...

I have an L3800, I have a disc mower on it now and the hyd cyl on the disc mower is single acting. The hyd cyl on the disc mower will not hold the mower level. I have two outlets on the back of the tractor, for use when using a two way hyd cyl. Any ideas or suggestions on how to stop the...

My L3800 4x4 HST with 77 hours on the meter has started leaking oil. It is comming from the the seal between the left (range lever side) axel assembly and the center section of the rear end. Have any of you guys had this problem? What did it take to fix it? Is there a flat rate price on...

How good are the kubota mowers? I'm thinking about a BX22xx with mower. I've never been around kubota mowers and need some good information before I buy anything. Thanks for you replys.

Have any of you guys built a cistern ? What did you use, platic tank, concrete culvert, bricks etc ?

My L3800 HST arrived yesterday. On the Kubota website it says that it has a live pto, but in the manual it says you must use the clutch when putting the pto in gear or takeing it out of gear. To me a live pto does not need a clutch to be put into gear. What am I missing?

Can hyd outlets be added to a L3010 / L3410 ? What would be a ball park price to have this done? Would either of these tractors have enough hyd system to run a 4 x 24 inch cylinder on a log splitter? Thanks for your ideas and suggestions.

How much HP do I need to run a 60" tiller and a 60" rotary mower? Would a 3215 be enough tractor? I would like to stay 60" or less in width of tractor if possible. Thanks for any ideas or suggestions.

How many hp tractor do any of you reccomend to run a 4' rotary mower? I have a 26 hp gear drive and it will run a rear mount 66" finish mower but not to my satisfaction. I'm wondering what it will take to run a 4' rotary(bush hog type) mower satisfactorally with a hydro trans. This will be in...