Search results

The radio in my ck30 HST does not play in the ACC position of the ignition switch. It only plays in the ON position. How big a job is it to get it to play in the ACC position so I can listen to the radio while stacking the wood I hauled in from the woods. The cab is factory. Does listening in...

Raise the roof and you will see the nuts on each end of the filters. They come off hard because they are painted. Filters run about $50.

The change in RPM is due to the hydraulic fluid warming up and offering less resistance to flow drawing less engine power to run the pump.

Had an hour today, took the roof off, traced the blue wire with the white tracer from the motor to a relay and replaced it. Problem solved thank you perrypower for the schematic.

That's the one. Thank you. In your experience as a dealer, any thoughts on the problem?

Thanks but this appears to be the dash cluster. What I need is the diagram for the roof console that shows wiring for the heater parts.

Does anyone out there have the wiring diagram for a 2012 CK30 cab. My dealer does not even have it in the shop. My heater fan only runs on low. The original 2 way switch showed continuity in both positions but I bought and installed a new one - same results. I am looking to see if there is a...

Broke the glass door on my 2012 ck30 HST. Reply from Kioti parts "Out of Stock" Suggestions?

Is the heater fan in the cab wired to a relay after the switch? Everyting else seems to have a relay.

I live in Northwestern Oxford county in Maine. I have used Rotella T6 full synthetic 5W-40 year round since my 50 hour oil change. I have never had to double cycle or manually cycle the start sequence in the 8 years I have owned it. It starts faster than my gas powered truck and no exhaust smoke...

Last February my cab heater stopped working on high speed. Thinking it was the switch, I replaced it and still no high speed. Knowing I had to remove the roof, I put it off until now. I got into it yesterday with meters, jumpers, etc. Switch is good, continuity on both positions. switched...

How hard is it to remove the roof to access the heater fan. It is only running on low speed. I want to get this fixed before the snow flies. While I am in there I would also like to rewire the radio so it works on accessory. It only works when the ignition is in the ON position [engine...

I am about to finish my 400 hour maintenance on my 2012 CK 30 HST with a cab. I changed the engine oil, oil filter and fuel filter last Tuesday and the gear oil on Wednesday. I have a big, old storage bin to drain the fluid into and will do each side and drop the filter before taking out he big...

I have a 2012 CK30HST that surges in reverse especially in low range. Forward is fine at any speed any gear. This occurs mostly at low/creep speeds like running the rear PTO snow blower. There is 300 hours on the tractor. Is this an adjustment problem like the linkage or a major problem?

I read a lot of posts about the relays on the firewall being generic and available at NAPA. I have a 2012 ck30HST and would like to have some spares available if I do not hear the click when I turn the key or the glow plugs do not heat. What is the NAPA part number to replace any of those on...

After reading the post about the CK20 oil fill location and warning I went out to see if I had something similar. I have already changed the oil three times with no problems adding thru the port in the valve cover which is labelled "oil inlet" in my manual. I found something with an orange...

Is there anyone out there who knows how I can make the radio in the cab work when the ignition key is in the Accessory position and in the On position? Right now it only works when the engine is running. I would like to be able to listen while working outside the cab while doing things like...

I was wondering if there was a way to tap off the loader block with long hoses to run a 3 pt. log splitter? And if there was, what two colors to use. The hoses and connectors would be cheaper than a rear remote kit.

I was greasing the loader and noticed a bolt on the other side of the zerk had backed out a little. I tried to tighten it and it just spun. I backed it out to see if it had snapped and it had not. I tried to put it back in and it just spun. I went to the other side of the hoist and removed...

What are you guys out there running for pressure in the rear tires? The manual says 45 but that seems awful high. I ran 24 in the rears on my TLB Kubota.

Just finished the 50 hour oil @ 59 hours. The oil coming out was the same color as the stuff going in--light tan. No soot - no discoloration. On my Kubota, it was black after about 5 hours on the clock. Is this common?? I was expecting maybe a little MORE discoloration due to the newness...

Has anyone out there used a Wood Maxx? They look good and are the heaviest 60 inch blowers listed. They ship right to your dooryard. Time to replace my old McKee!

Still trying to figure out my CK30 HST with a cab. Thanks to the forum I got the radio on N.A. frequencies. This time I am wondering what the yellow handled lever next to the parking brake lever does. I cannot find a reference to its function in the manual [or most of any thing else in the...

Has anyone out there ever tried a Wolverine oil pan heater on a Kioti CK30? I do not see any mention of them on the forum. I had one on my Kubota and it worked like a charm. I think it was 125W and 4 amps.

Just replaced my 15 year old Kubota with a CK 30 HST with a heated cab..getting old I guess. I have some questions on the cab. What does that black dial in the roof do? I think it must be a heater control, It has a circular arrow that is wide at one end and tapers. Is that electrical...

Any feedback on service , etc from this dealership?