Search results

My pump works, but the seal of the PTO shaft leaks too much. I have never taken one of these pumps apart. The only youtube is about rebuilding a "hydro" brand pump, which is straightforward IF you have the right tools and jigs to hold the pump and parts. I don't. Has anyone had one of these...

I am told by Messicks that my Kubota L4560 pto powered backhoe pump is rated at 6.5gpm and 2250psi @ 600rpm. About $810. What if I replaced it with a Prince pump (http://tinyurl.com/kv3dej2)? How much larger pump would be helpful? Interesting that the 21gpm and the 11.9gpm are less than the...

This 4560 3 pt backhoe, with its own hyd pump on the pto, is on a L3560, all built in the early 90's. Had to remove and repair the pump this summer as the connector to the 3 pth was worn and pump wobbled significantly on it. So the backhoe has not been powered for about 5 months. Finally got...

It works perfectly until the temp gets cold- it is about 20F here now- and it locks up until the tractor runs long enough to get to operating temp. 15 to 30 minutes. Any cure for this? I use Kubota brand fluids. I might be a little beyond recommended change intervals now. Tractor has about...

I need five old style backhoe teeth and my local dealers do not even understand what they are. Unlike newer backhoe teeth, these have no pins. Rather the tooth is manufactured with what is roughly a "U" shaped slice in the both sides. The "U" is squeezed, pressed or beaten into a dimple on each...

I need five old style backhoe teeth and my local dealers do not even understand what they are. Unlike newer backhoe teeth, these have no pins. Rather the tooth is manufactured with what is roughly a "U" shaped slice in the both sides. The "U" is squeezed, pressed or beaten into a dimple on...

I have a vintage 1991 L3650 which I recently started and 2 of the 3 warning lights (clogged air filter and not charging) not only came at start, but stayed on. This has not happened before. I cleaned the air filter, which needed attention but which was not clobbered and inspected the fan belt...

The valve above the clear fuel filter bowl has 3 positions, two on and one off. Fuel flows from none of them. Overnight, enough fuel will seep into the bowl to refill it. You can watch the fuel level in the bowl go down while the tractor runs a few seconds and then stops. Fuel gage read about...

L3650 is overheating both at idle and when working. Temp indicator goes about 7/8 way to red. I replaced the thermostat and fan belt. Radiator fins are clean outside. Inside some (30%) thin white scale. All tubes open. No leaks from water pump, but there seems to be no flow from the engine into...