Search results

I upgraded to a new 3033r with factory cab and therefor no longer need this heater acquired to install in my former model 4100 with Curtis Cab. This powerful forced hot water heater packs 20,000 BTU/hr. and features a built-in high-low speed fan. An in-line shut off valve quickly converts this...

I am hoping this image appears to supplement my post above.

The ball and socket joint end of the power steering cylinder near the front tire needs replacement. Unfortuneately, unlike the part diagram MP17990 on the JD parts website that breaks this cylinder into 22 separate components and assigns the portion I need to replace as component #2, my JD...

Can a JD 47 Backhoe be attached to a 4100, perhaps with a special bracket?

I need to replace the front tires on my JD 1999 4100. The original tires are Bridgestone turf tires. the rear tires are still good, but I had to replace the front tires. I replaced the front tires with a Carlisle brand turf tire. However, they did not last long at all! The Bridgestone are no...

I would appreciate help locating a fairly recent post (within last month or two a most?) featuring an awesome attachment for a skidsteer that grabs a log, cuts it to length and splits it, all in one. Thanks.

I would welcome and appreciate input on the value of the following tractor: 2007 JD 3720 with 400 hours, loaded Cab with all available accessories New, once used 60" 7 iron Mid Mount Mower Deck Removeable front end loader with bucket Dealer acquired this unit in connection with a trade-in and...

Despite cleaning after each use and before winter storage, the roller pump on my Fimco sprayer is locked up. Any suggestions how to losen it up and get it working again?

________________________________________ Below is my question orginally posted in the wrong manner. Hopefully I have also successfully added a photo that illustrates what I was describing: Kennyd, I need your help please! (I apologize in advance to any of my fellow TBNrs if this is the wrong...

Hello Kennyd, Thanks for your suggestion for me to post my question in the appropriate place and manner as follows. Also, I will attempt to include a photo that shows what I was describing: Kennyd, I need your help please! (I apologize in advance to any of my fellow TBNrs if this is the wrong...

I wish to relocate 6 full pallets of excess bricks. I have a 3-point pallet fork attachment, however, my tractor does not have sufficient power to lift the pallet. Short of removing, say half of the bricks from each of pallet, are there other suggested methods to move these pallets? 1. Is...

Can someone please provide the lifting capacity of my JD 4100, 410 loader? Any suggestions as to the proper fork attachment for my equipment? I don't want to over-purchase an attachment that is too heavy and therefore limit my lifting capacity. I was thinking I would purchase the lightest set...

My seat on my JD 4100 is showing evidence of intial phases of cracking and/or splitting on the upper, outer edge. Aside from applying tape, are there other options I should consider that will repair the existing cracks and is there anything I can do to prevent or at least delay future cracking...

Are there any percieved drawbacks of using a 3 point hitch pallet fork attachment on a FEL by attaching it to the FEL using a HF/Speeco/JD Imatch or similar brand quick hitch that is welded to a quicktach/universal plate? Would this approach be any less disireable than a standard pallet fork...