brnt
New member
I am in the process of putting a loader on my Beaver and have run into a road block. The guy at surplus center tells me that I have to have a return line to the tank in order to use the valve that I am thinking about using. Where does the return line go? The tank is the transmission case. I have manufactured the block that bolts on the pressure line at the transmission case and have the fittings in it to run pressure to the loader valve and back to the transmission to run the three point lift cyl. in the transmission. I was planning on using a power beyond set up but where would the return line go? All of the pictures I have seen only show two lines. One going to the loader valve and one coming back to the block. I am lost here. If anyone has any insight on how to plumb this up I sure would appreciate the information.
Thanks..
Thanks..