JC - the diagram is particularly helpful. Thanks. Without a service manual I was guessing. After reading it things don't seem so tough. Certainly easier than auto's.
Local dealer has both the friction plate and the throwout bearing so I'll pick those up and get going.
Will the front and rear pieces of the tractor come apart easy once I remove the bolts connecting the BH from the engine or are there press fittings that will give me trouble? I plan on using jack stands under the rear and a rolling floor jack under the front end and pulling the front away. It appears I won't have to remove the bell housing from the rear part after the split. That should save time.
Thanks again.
Local dealer has both the friction plate and the throwout bearing so I'll pick those up and get going.
Will the front and rear pieces of the tractor come apart easy once I remove the bolts connecting the BH from the engine or are there press fittings that will give me trouble? I plan on using jack stands under the rear and a rolling floor jack under the front end and pulling the front away. It appears I won't have to remove the bell housing from the rear part after the split. That should save time.
Thanks again.