Riding Tailboard
New member
Hello I am new to the forum and am amazed at the value and quantity of information available here. I have been reading a lot of post and have learned much, but still need some good advice. I have some specific questions regarding the install of my rear remotes and 3 spool valve. Please help me finish my project.
1. I Purchased the Prince 3 spool 1 detent and 2 spring centering, open center w/ power beyond. At this time I do not need the PB should I install the PB adapter and then Plug it or install the plug as shown in the last picture?
2. I purchased a hyd block for a woods backhoe to use as a supply and return manifold. The fittings were 3/8, I think this limits my new remote system to 7GPM whereas the tractor will put out 10.8gpm. So rather than limiting the remotes I thought I would get my supply line from the FEL. Is the plug shown on the loader valve a power beyond and should I use it to supply the new stacking valves? I would then use the rear cover as my return line.
3. If the plug on the loader valve is not PB, where do I get my supply from? I took a picture of the junction under the HST pedals and dont see another port.
My tractor is a NH TC40DA W/ loader
My plans for the remote setup include hyd top link, log splitter, and the occasional bailer operation.
Thanks in advance
Andy
1. I Purchased the Prince 3 spool 1 detent and 2 spring centering, open center w/ power beyond. At this time I do not need the PB should I install the PB adapter and then Plug it or install the plug as shown in the last picture?
2. I purchased a hyd block for a woods backhoe to use as a supply and return manifold. The fittings were 3/8, I think this limits my new remote system to 7GPM whereas the tractor will put out 10.8gpm. So rather than limiting the remotes I thought I would get my supply line from the FEL. Is the plug shown on the loader valve a power beyond and should I use it to supply the new stacking valves? I would then use the rear cover as my return line.
3. If the plug on the loader valve is not PB, where do I get my supply from? I took a picture of the junction under the HST pedals and dont see another port.
My tractor is a NH TC40DA W/ loader
My plans for the remote setup include hyd top link, log splitter, and the occasional bailer operation.
Thanks in advance
Andy