Anonymous Poster
New member
- Joined
- Sep 27, 2005
- Messages
- 0
I have a need for a small sand blaster so I can get my JD322 lawn tractor and deck ready for fresh paint. A lot of the paint had peeled and there is just some surface rust. My brother has an older Craftsman. He loaned it to someone and the delay is holding me up. Considering getting my own. Didn't want to as it would sit after I finish up a few of these projects. I'm sure I could find occasional use for it.
My question is this. Does anyone have any vendor suggestions? Using the Sears model I have learned about wear. The first tips were metal and wore out fast. Switched to porcelain. That helped a lot but then the threads started wearing where the tip threaded in. Wondering if this technology has been improved much since the last time I used the Sears model.
I have searched the Internet and have seen some listed but they don't give a lot of details on them. Was hoping to get some advice.
Craig
My question is this. Does anyone have any vendor suggestions? Using the Sears model I have learned about wear. The first tips were metal and wore out fast. Switched to porcelain. That helped a lot but then the threads started wearing where the tip threaded in. Wondering if this technology has been improved much since the last time I used the Sears model.
I have searched the Internet and have seen some listed but they don't give a lot of details on them. Was hoping to get some advice.
Craig