Just bought a Ford 2810 tractor that is in reasonable good original condition. Brakes need adjusting, pedals go pretty much all the way down, but will stop the tractor. Need some advice on...

Looking for the hydraulic fluid fill port on a ford 2810 pretty sure it’s the grey square plug above the top link

ive got a 2810 and im ready to pull my hair out trying to get fuel to the 3rd and last injector . 1&2 both bled out fairly easy AND IVE BEEN AT THE 3RD ON AND OFF FOR THREE DAYS. Anyone care to...

I have a Ford 2810 that has a line leaking where it attaches to the pump. It's the line that to the far right, in the center and is a flared fitting. It had a yellow substance on some of the...

I have a 1965 Massey 135 that runs real well and I use quite often. It is pretty much all original as tractors go and it does what I need it to around the farm. However, it is older and I want to...

ive got a power steering assist cylinder leaking on my 2810,,I have everything loose but cannot get the ends out,,i have the nuts off the back, i tried tapping on the nut on the front one but no...

Hey guys! Im keeping my fingers crossed that one of yall will be able to help me figure out a annoying problem my tractor has been having for about 6 years now. This tractor only has 400 hours on...

87 model Ford 2810 with 7410 loader. 3 Point still works fine. Have already replaced filter and checked fluid level. Loader lift has gotten slower each time I use it for past 5 times or so and...

I just wanted to know in aligning the steering gear shaft, where is the gear shaft suppose to sit? In the center, left or right, so that the tractor can turn left and right.

Hello. New Member here, searching for advice. I have a 1987 Ford 2810 with New Idea FEL that I purchased used about 15 years ago. It currently has 2700 plus hours. I have 25 acres mostly flat...

I was unable to find this on the net last week so thought I would post for everyone. May help me again in the future too. Lol

Hey all.. I am looking at a 1990 (ish) Ford 2810. It has got 4wd which as I have gathered is a pretty rare item. I assume it was installed after initial manufacture. The tractor is a little...

Just enjoying a beer and freshly waxed Ford 2810. Work is done so now time to relax and enjoy. This tractor only has 445 hours a d is all original. Anyone else like Ford tractors this much...

I started a thread in another forum and haven't had much luck so I thought I'd start one in the Ford/NH forum. I have a Ford 2810 (approximately 1988 year) that's not used a whole lot but now...

I've came to this site plenty of times for information but never joined because I always found what I needed. After much searching here and other places I can't find what I need to know so here I...

I have lost my owner's manual to my 2810 Ford Tractor. Please tell me where the power steering fluid reservoir is so that I may add some fluid. Someone said it was to the left of the engine...

OK so yesterday i serviced my new to me 1989 Ford 2810. Changed oil/filter, coolant, fuel filter/water separator, 2 new air filters, transmission oil, hydraulic oil / filter etc. The engine oil...

Guys i have found one of these with 500 supposedly (gonna look tomorrow) original hours. This is a 1 owner tractor and husband died so wife selling it. Whats it worth if in good condition like...

Have a 2810 that has it's flow valve stuck and I need advice on it. Does anyone know how to free the control knob without breaking it or the valve? Help with it would be great. Thanks

I need to have a steering box rebuilt for a Ford 2810, wheres a good place to have this done and any ballpark figure of how much this will cost.

First time to try this . I have a 2810 series II and the PTO will sometimes not engage immediately. Have to move the tractor to engage. Apparently hyd. engagement some way. Any ideas, also how...

I looked at a Ford 2810 yesterday. THe meter shows about 1200 hours. The tractor appears in over all good shape. The power steering did not seem to be working well, if at all. Does the PS work off...

Just want to say hello. I just joined today.

Anyone have or had a Ford 2810 and can tell me how well they do with a 6ft bush hog? I have a Ford 4000SU with tons of hours and has lost some power so just curious how a low hour 2810 would do...

I'm gathering parts for Cab Air Conditioning and wondering if anyone has one of the above tractors or has experience with the A/C setup. I need to know where the compressor is mounted and...

I want to know the good and bad about Ford 2810 tractor 1000 hr. has a FEL ,will use a 6ft R/C and B/B will do just regular work around the old home place I know there some tractor to stay away...