I have an older L2850. The previous owner really did a number on rerouting/rewiring the electrical wiring. I’m getting ready to sell it so I replaced the battery and the cable going to the...
So first of I made a stupid mistake. Someone left the ignition switch on after driving for the day and it sat for a couple of days and died. I Just started working with this tractor so am very...
Would anyone know the correct size of tires to fit on the rear of my old l2850 if it has 275/65×16 turf tires on front
or what tires should be on the front with 44x18 turf tires on rear
Hi Guys~
About to pull the trigger on an L2850 from a close family friend. They are the original owners and it hasn't been used much at all the last 15+ years (but it has been serviced regularly...
I purchased a tractor today DOA, it won't start and the PO seemed to indicate it ran great then it didn't run at all.
I have hopen that it is something simple.
I haven't been able to verify GP...
I have what I believe to be a '88 Kubota L2850. It runs great, has a brand new battery. I just bought it and had the battery go dead after a week or so. No big deal I thought, I figured maybe the...
I drank the orange koolaid Sunday :)
I need advice on what oil and filter to use to change the oil. It looks pretty black but I'm not sure if that's a diesel thing or it's just dirty. I'm going to...
Rear rim on my L2850 rusted out. Could someone tell me a good place to get one please. I live in Cincinnati but would have it shipped if I can't find one here. Size is 13.6-24. Thanks for your help.
Hi,
I was replacing the front seals on my l2850 and I replaced the small lower bevel gear also. Unfortunately when I put everything back together and tighten the bolts the hub assembly doesent...
The nephew wanted to check the oil levels and backed out the pto pivot pin/bolt, and it dropped down into the trans case. Now pto selector lever won't work and the pto is on all the time.
How to...
The nephew wanted to check the oil levels and backed out the pto pivot pin/bolt, and it dropped down into the trans case. Now pto selector lever won't work and the pto is on all the time.
How to...
Hello all! I purchased a used l2850 with fel,it won't move forward or backwards until the fel is raised all the way up? Power steering is intermittent too. I have chaned the hydraulic fluid and...
I am new at this as I have had same equipment for 30 years and now the old bush hog and it took me that long to get the hang. Slow learning curve I guess. I had to relearn how to attach each time...
My L2850 battery alert light would come on after start-up, then flicker after a few minutes, then go out. The manual claims that this indicates low fluid level in the battery.
My nine year-old...
I am trying to verify if there is any difference in the (gear) drivetrain between these two tractors.
A friend is going to purchase a set of turfs from my L3200 and the turf specs are different...
I want to run a log splitter on my L 2850 in addition to the factory front end loader.Where would be the best place to tie in the hydraulics without using a selector valve so that both implements...
I have 12.6 volts to my starter but nothing to my panel, no lights no nothing. I suspect the fusible link. Can some one tell me how to remove it. I tugged on it and it didn't want to come out of...
I'll just start a fresh thread since this is a different machine I was just told about. An l2850 with under 500 hours FEL and a New Holland B124 frame mount back hoe. Can't find any specs on...
Can someone please post a picture of the position control stopper and the L2850. Mine fell off and I am ashamed to say that I can't figure out how to get it back on. I bought some 6mm bolts and...
I've got some leftover parts after fixing up my l2850:
Asking a Jackson for the lot Send a PM if you wish info.
Used: 17331-12140 Muffler Clamp and mounting hardware- very good condition...
Hello,
I recently installed new injectors in my Kubota L2850 with a v1702 engine. I also rebuilt the fuel pump. Since then, it has been under powered and smoking a lot. Any suggestions?
Thanks
I have an 86 kubota L2850 with 1950hrs on it.
There seems to be a fueling issue. It is not compensating for load (no smoke) and is low on power, bogs in 3rd/4th gear on slightest grade with 0...
i got the service manual and ran pressure test here are the results p5=75psi, p6=450psi , p3= 450psi p4= 450psi service manual states fault in either modulating valve or gate valve .. i removed...
As the title says...
One of ths tractors at work, an '86 L2850 mfwd with woods loader, needs some wiring repairs under the hood. Seems the entire harness has been spliced... rumors of a fire at...
I Am looking at a used Kubota L2850 and I was just wandering what to look for specific on this model? Was it a good reliable tractor? What is a good price for one that 2,300hrs and in good...
I've searched several times, and can't seem to find the answer. I am working on my folks L2850 with a 2 stage clutch and am trying to adjust the clutch. The PTO works great, however the clutch...
Background: I am retired and money is a concern. My new to me L2850 4wd with BF500 loader is used mainly for road maintenance, tilling the garden, placing occasion rip-rap, moving snow, clearing...
Hello,
My tractor has developed a wobble. When driving on a hard surface it can be felt once per rear tire revolution . I'm pretty sure the problems on the right side. I used the tractor for...
I'm considering buying an L2850 (1986 or so); asking price is $9500. It goes great, but there's weeping from the top of both spindles in the front axle. Is this a big deal?
Second: I lifted...
I'm going to get a box blade for my L 2850 4wdr. If I can't find used, there is a $40 difference in price between a 65" and 72" blade. I expect to do some field leveling when I first get the...
I have been frustrated for years by the poor 35W lamps in the L2850 headlights. I use a set of 55W halogen lamps on the ROPS to help forward and to the rear but have longed for a decent set of...
The tach on my new to me L2850 does not work. I know that the cable is functional and that it is turning. The tach basically does not move. At high rpms it will bounce at the bottom a bit...
My L2850 tachometer is not working. At high rpms it barely bounces off of zero. The hour meter is working.
Does the tach cable drive both the hour meter and tach?
Any thoughts on repairs...
My L2850 will not start up until I let it sit for at least 30 to 45 minutes after I have been working it hard for an hour or two. Yesterday after tedding hay for two hours it would not start until...
First cylinder not firing. Full voltage to glow plugs, removed it glows fine. Cracked the fuel line when running, all cylinders change the idle except the front cylinder. Fuel comes out of the...
Hello,
I just bought my first tractor, a KUBOTA l2850 2 wheel drive. It currently has lawn tires on the rear and I want to replace them with ag tires and wheels. Does anyone know the part...
My Kubota L2850 has not been started for about 18 months . It has been parked and covered outside in a mild, mostly dry climate near Sacramento. After checking my manual for any start up tips...
I am a newbie to Kubota tractors. After running my newly acquired L2850 in 4WD for maybe 20 minutes on my hilly property, I parked and shut it down on the driveway and went inside my garage. I...
GUys, posted in pricing forum but it looks quiet so here it is...
Looking at picking up this private sale 1986 4WD with just under 1800hrs.
Starts nicely, runs very strong. cosmetically a 6 out...
We have a Kubota L2850 2 wheel drive tractor. I started it up today and it was blowing oil out the dipstick tube. It looks like there is hyd fluid in the oil. I can't figure out where it's coming...
I have noticed for a long time a small about of grease on the inside of both of my wheels, however after working my tractor harder than normal yesterday I notice it very very wet with grease on...
Im thinking about buy this tractor with fel and backhoe. What is involved in taking the backhoe off and putting a 3pt on to use scrapblades and other attachments. If any one knows a ballpark...
Hi Everyone,
I'd appreciate any help or advice on my situation. I'm an OK mechanic (or so I thought), but electrical problems drive me nuts. And it appears that's what I have here.
Our work...
i'm looking for a running board for an L2850. part # is 32430-2992-0
used is preferable. does anyone know where I could find used Kabota parts?
thanks.
Does anyone have any advice on a clutch and flywheel for an L2850?
It seems the tractor wasn't driven from march until the summer and the firewall may have rusted against the flywheel.
The...
What is a Kubota L2850 with 500 series loader and Kubota sub frame backhoe worth?It has 1000 hours and the tractor looks like it was mostly kept inside.The hoe has had some welding done on it and...
What would be a current model "equivalent" of an '89 L2850?
L2800? L3400?
I know you can't get the same thing but what would be the most similar model today?
My L2850 will not keep running unless I pre heat before starting. This is now happening even when it is 70 degrees outside. I changed the fuel filter and put solution in the fuel to eliminate the...
I have a 1987 L2850 and am going to put a L4950 backhoe on it. I have the sub frame but no instructions on how to mount it. If some one could help me with where the mounting points are or even...
I have a 1987 Kubota L2850 that I am going to put a L4950 backhoe on. I have the sub frame kit but need a little help locating where the sub frame mounts to. Any advice and some pictures would be...
This is my first post and first potential tractor purchase. I need a bit of help deciding on which tractor to pick.
First I'll give you a bit of info about me... My wife and I just bought a...
Does any one know about gearbox, rear axle and hydraulics on this tractor. I have no manual. Can find one sight glass for oil level on LHS of gearbox, do all 3 use one common supply of oil? as...
My first posting.
Have opportunity to purchase a Kubota L2850, 4x4, FEL, Backhoe & Brush Hog. This machine has 2,250 hours on it. I'm told that it has been well maintained and has had only one...
Hi all,
I'm new around here, I've asked a few questions and have received a lot of great feedback. I finally decide to get a dedicated lawnmower (Kubota ZG23) for my lawn and have been looking...
I stopped by a dealer today and saw an L2850 for 16K. (this is in Washington state). The body and engine appeared to be in pretty good shape, looked like it had been garaged when not in use. I...
What\'s my L2850/FEL/BH/etc. worth?
Whoops... I posted this first in the "general" forum but realized it would be more appropriate here... I'll go and try and delete that one.
Also, I found...
About 5 months ago my L2850 suddenly had no power to the starter, lights or anything. I removed the battery and had it checked to find it was fine. I put it back in the tractor and it fired up...
I have a Kubota L2850. I need to clear a long driveway in upstate NY--very long. Any suggestions how I can fit a snowblower on the front and which model to get? thanks.
Hey all, I was wondering if anyone out there knows if the rear PTO on my 1990's L2850 (Standard) is supposed to stop turning when I push in the clutch? I know on my old B7100 HST it did but not so...
I found a used L2850 4X4 with 1500 hr. on it. There is no FEL or BH on it. I would have to purchase these implements afterwards. I need the tractor to dig ditches for utilities and then...
What is this baby worth??? I like the tractor, but, it seems darn expensive!
TRACTOR, Kubota L2850, 4x4, w/ HD loader (model 500), 33HP, VERY clean, 265hrs, always garaged, Gannon box/ripper w/...
I currently have a L2850 (1200 hrs) 4 W/D W/LA500 loader and Woods 7500 BH. I am looking at a used '99 L3010 (300 hrs) 4 W/D w/woods loader and woods 9000 BH. If I get the 3010 I would sell the...
I just bought a 1985 Deisel 4 wheel drive L2850 with 1750 hours, with BF500 kubota front end loader, new kingkutter "bush hog", old woods finishing mower, 5 foot box scraper, boom and trailor...
I would like to buy a good used mid mount mower to fit a L2850. The closer to East Tennessee the better.
Thanks
ckyker@lcs.net "] ckyker@lcs.net [/email]