Tilt cylinder questions
- Thread starter Knight
- Start date
- Views: 4128
Willl
Elite Member
https://www.surpluscenter.com/home.asp
Bore = the diameter of a cylinder.
Stroke = the amount of travel from one end to the other with above cylinder.
Have you never heard of Google ?
Bore = the diameter of a cylinder.
Stroke = the amount of travel from one end to the other with above cylinder.
Have you never heard of Google ?
I meant, the typical bore and stroke size used.
MtnViewRanch
Elite Member, Advertiser
- Joined
- Mar 19, 2005
- Messages
- 10,643
- Tractor
- Mahindra 7520, Mahindra 3215HST, Case 580 extendahoe, Case 310 dozer, Parsons trencher, Cat D6,
My guess would be a 4" stroke with either a 2" or 2 1/2" bore.
tractordriver
Bronze Member
- Joined
- Sep 25, 2007
- Messages
- 65
- Tractor
- mahindra 3525
thats QUITE ignorant. thats what a forum is for Q&A.
Willl
Elite Member
jinman
Rest in Peace
- Joined
- Feb 23, 2001
- Messages
- 20,387
- Location
- Texas - Wise County - Sunset
- Tractor
- NHTC45D, NH LB75B, Ford Jubilee
Brian mentioned a 4" stroke with a 2-1/2" cylinder. I think mine is a 6" stroke on a 3" cylinder. My cylinder is quite large in diameter. The ideal stroke would be the same as the adjustable link you will replace with the cylinder. My adjustable link could be adjusted a little over 6", so this was the best choice for me.
Attachments
MtnViewRanch
Elite Member, Advertiser
- Joined
- Mar 19, 2005
- Messages
- 10,643
- Tractor
- Mahindra 7520, Mahindra 3215HST, Case 580 extendahoe, Case 310 dozer, Parsons trencher, Cat D6,
Well I looked at some dimensions that I have and it looks like a 6" stroke will work for your side link. I think that with your size tractor that you would be fine with a 2" dia cylinder. A 2 1/2" dia cylinder might be a little cramped on your tractor, but then again it may be fine.
As an example, on my Mahindra 7520, I have an 8" stroke with a 3" diameter, but on my Mahindra 3215 I have a 4" stroke with just a 2" diameter.
I hope that some of this info can help you.
As an example, on my Mahindra 7520, I have an 8" stroke with a 3" diameter, but on my Mahindra 3215 I have a 4" stroke with just a 2" diameter.
I hope that some of this info can help you.
Willl
Elite Member
Jim, I think the op was talking about his FEL tilt cylinder.
jinman
Rest in Peace
- Joined
- Feb 23, 2001
- Messages
- 20,387
- Location
- Texas - Wise County - Sunset
- Tractor
- NHTC45D, NH LB75B, Ford Jubilee
Willl, wouldn't that be the curl cylinders instead of tilt? Since he asked about a single cylinder and called it "tilt," I believe he is talking about his 3PH. In fact, I think you thought he was asking for a definition when he was looking for dimensions. Either way, if he is talking about the FEL, I'm sure he will tell us.
