5740 top and tilt

J_J · Dec 2, 2011

MartianTractorMan,

Why not trace the QD's back and note any connection all the way backto the pump.

Since there is not a jumper hose across the QD's, they must work off a valve.

A manual for your tractor would be a good thing to have, and a 3000 psi hyd gage.

MtnViewRanch · Dec 2, 2011

My guess is that he has 1 set of remotes and just needs to add a 2nd set. If he pulls on the lever and the engine loads, then I would guess that is what the situation is.

Martian · Dec 2, 2011

MtnViewRanch said:
My guess is that he has 1 set of remotes and just needs to add a 2nd set. If he pulls on the lever and the engine loads, then I would guess that is what the situation is.

That is exactly the case when I pull the valve. Dealer told me the lever was for a MMM but I guess the MMM hydraulics could hook up back there

MtnViewRanch · Dec 2, 2011

MartianTractorMan said:
That is exactly the case when I pull the valve. Dealer told me the lever was for a MMM but I guess the MMM hydraulics could hook up back there

This is good news, you're half way there.

RFB · Dec 4, 2011

Brian,

What is the total extended length of a top link for a L5740, and does it have the combo Cat1/Cat 2 ends like the Kubota manual toplink?

Thanks,

RFB

MtnViewRanch · Dec 4, 2011

RFB said:
Brian,

What is the total extended length of a top link for a L5740, and does it have the combo Cat1/Cat 2 ends like the Kubota manual toplink?

Thanks,

RFB

I sell 2 different units for them. Either 20"-30" working length or more commonly purchased is the 22"-34" working length. I use a 2 1/2" dia cylinder to build it and yes it has the cat 1 tractor end and cat 2 implement end.