3 Pt Question

MDA1775 · Jul 23, 2012

I've read several different posts on this and still have a couple of questions. When I set the brush hog at the desired height it tends to drift down. I have read that there is a lever or bolt that can adjust it but I can't find it or don;t know what I'm looking at. I have started using the large lockout knob for travel with the hog on the tractor so that's working fine. I understand don't use the hydraulics with the knob closed.
I did find a screw with a butterfly nut on it on the 3 point lever slide and by adjusting that to the correct height it's holding the hog in place pretty well. Is that the only adjustment I need to use?
Also, when mowing does it matter how fast I go (terrain and safety dependent) as long as the PTO is in the #1 position which to my understanding provides the desired 540 rpm speed?
Final question (for now) I fat fingered my profile but can't seem to edit it, how do I do that? My tractor is obviously a YM not a YN...

Thanks for the help.

Mark

joe swanson · Jul 23, 2012

A few question if I may. What model do you have? Do you have draft controlif so how how is it set??

Joe

MDA1775 · Jul 24, 2012

I have a YM2000D and unfortunately I have no idea if I have draft control. I believe the 2000 is similar to the 240D sold here but I am not positive. Thanks, Mark

ricklman · Jul 24, 2012

MDA1775 said:
Final question (for now) I fat fingered my profile but can't seem to edit it, how do I do that? My tractor is obviously a YM not a YN...

Mark

My Home (Icon at top of Page) -> Edit Profile on left side of new page.

Hope it helps.