Looking for Easy Change Hydraulic Line Bracket/ retainer

[nc redneck]

I have a WR Long 4 in 1 bucket and hydraulic forks. They both quick disconnect at the joystick. So far I have used zip ties to hold the hydraulic lines from there to bucket or forks. Gets to be a pain after 100 or so change outs. I am thinking someone makes a good quality no tool hydraulic line bracket. Any thoughts or ideas greatly appreciated.

 

[J_J]

Is this what you are looking for?

Tube and Pipe Clamps

 

[nc redneck]

That sure beats zip ties, have any ideas on no tool option ?
Thanks
Scott

 

[J_J]

McMaster-Carr

That is about as no tool as you can get.

 

[Harry in Ky]

Why not run the hoses from the valve down the loader frame along with the other lines and mount the quick connects down near the attachment? With a little thought and experimenting you should be able to get the hose length and configuration on the attachment to be functional with minimal interferance. I have mounted several grapples this way and it's worked out well.

 

[Piston]

Why not run the hoses from the valve down the loader frame along with the other lines and mount the quick connects down near the attachment?

That's what I would do,as well. I still had a lot left over at the FEL though and was worried about the hose getting caught on something, so I bought a package of these and mounted one to the crossbar on my FEL. I run the hoses through it and it keeps them out of the way. http://www.amazon.com/Original-Quic...d=1371301388&sr=8-1&keywords=quickfist+clamps

 

[JerryG]

Surplus Center
A page of clamps
Surplus Center - 3/8" NPT QUICK COUPLER F/F S40-3
Quick connector bulkhead type if you decide to mount the lines permanently.