RedNeckGeek
Super Member
- Joined
- Jan 1, 2011
- Messages
- 8,747
- Location
- Butte County & Orcutt, California
- Tractor
- Kubota M62, Kubota L3240D HST (SOLD!), Kubota RTV900
70F at 6AM, now at almost 1PM it's 87F. All under sunny skies and very light breeze. I think it'll easily make it into the 90s before dark.
Started work on the FEL yesterday, tearing it down in preparation for bushing the main pivots. In the process I found the welds at both ends of the cross member had cracked, so I'll end up cutting that off and re-welding it with some reinforcing plate added. It's too heavy to lift as is, but I was able to use a couple of floor jacks this morning to move it out of the way so I could free up a bay in the garage for the work. But I think I'll leave that for an earlier and cooler start in the morning. Once apart, though, I'll be able to get each arm up onto the mill table to straighten out those bores.

Eric, that is what we'd call a brushog. I have a smaller 60" one, and use it to cut the meadow here. The terrain is steep and very uneven, and the resulting cut is rough at best. But it gets the job done as long as I manage not to hit any trees or rocks with it. I've had to straighten out the supports and deck a few times now when I got careless. The one pictured doesn't look that robust, but since most of what I've seen of England is groomed like a golf course, I bet it'll work fine for you. Very curious how the offset feature works. On the US versions, the spinning blade is driven by a right angle gear box in the center of the deck, and off setting has to be done with the support structure.
Good to see Spring taking a strong hold over most of the country now.
Enjoy the weekend, everybody! :cool2:
Started work on the FEL yesterday, tearing it down in preparation for bushing the main pivots. In the process I found the welds at both ends of the cross member had cracked, so I'll end up cutting that off and re-welding it with some reinforcing plate added. It's too heavy to lift as is, but I was able to use a couple of floor jacks this morning to move it out of the way so I could free up a bay in the garage for the work. But I think I'll leave that for an earlier and cooler start in the morning. Once apart, though, I'll be able to get each arm up onto the mill table to straighten out those bores.



Eric, that is what we'd call a brushog. I have a smaller 60" one, and use it to cut the meadow here. The terrain is steep and very uneven, and the resulting cut is rough at best. But it gets the job done as long as I manage not to hit any trees or rocks with it. I've had to straighten out the supports and deck a few times now when I got careless. The one pictured doesn't look that robust, but since most of what I've seen of England is groomed like a golf course, I bet it'll work fine for you. Very curious how the offset feature works. On the US versions, the spinning blade is driven by a right angle gear box in the center of the deck, and off setting has to be done with the support structure.
Good to see Spring taking a strong hold over most of the country now.
Enjoy the weekend, everybody! :cool2: