Finished up my version of the chain storage carrier. Nothing fancy. I wanted to avoid drilling holes in the tractor if possible. (After all, it is only two months old.)
I used a piece of 4" PVC and a cap cut the height off even with loader frame support.
View attachment 458177
To go along with my not drilling holes theme, I used a piece of angle that was about an 1/8" thick and wouldn't bend. I used one of the floor and step holes with a couple of washers and locknut to secure one side. Though I used a fancy stainless clamp to put mine on, a hose clamp or even another bolt washer nut combo would work fine I think.
View attachment 458178
On the bottom, was just a drilled hole through the cap and another set of bolt,washers, & locknut.
I didn't glue the cap on. I meant to but the friction fit of it when I pre assembled everything wouldn't come back apart so I figured "good nuff".
View attachment 458179
I still need to drill a few drain holes in the cap. I missed that and had painted it already when I caught it but that can be done on the tractor.