3rd Selective Control valve for 4310

[PerryWhite]

Right now, I have a homemade log splitter to use with the
3rd SCV. Later I plan on adapting my 6 foot rear blade so I
can angle the blade left or right without leaving the seat.
As for the still dreaming about it stage, I would like to make
a grapple log skidder for the 3 point hitch.

 

[csnow]

bringing this back from the dead. I just bought a 4310 and was looking at the third scv. Looks like the level comes up in front of the lift arm lever lock. did you have to cut a hole for that then and is it marked underneath? thanks

 

[MtnViewRanch]

bringing this back from the dead. I just bought a 4310 and was looking at the third scv. Looks like the level comes up in front of the lift arm lever lock. did you have to cut a hole for that then and is it marked underneath? thanks

I sort of doubt that you will get a response from Perry. His last post on TBN was April of 2013.

 

[beenthere]

csnow
Others with the 4310 or experience will likely give you some info, if Perry doesn't. Maybe a PM to Perry will help too.

Sounds to be some different than the 3rd SCV I added to my 4300.
There were good directions in the kit, if that is still available through Deere

 

[csnow]

csnow
Others with the 4310 or experience will likely give you some info, if Perry doesn't. Maybe a PM to Perry will help too.

Sounds to be some different than the 3rd SCV I added to my 4300.
There were good directions in the kit, if that is still available through Deere

I did a little more research and found out you cut the original panel which has markings on the bottom. Now I'm trying to find a good place to get a tech manual for the 4310. Thanks for the responses