davcog
Silver Member
Trying to remove blades. Are they Left or Right threads? Pretty rusted so got them sprayed down with liquid wrench. Don't want to turn in wrong direction.
Mowing Woods Brushbull BB48
- Thread starter davcog
- Start date
- Views: 3904
Deerherd
Veteran Member
- Joined
- Apr 9, 2012
- Messages
- 1,064
- Location
- Upstate, NY
- Tractor
- LS P7030 CPS, 2016 Bobcat E42, Ferris IS3100z w/37 HP Kawasaki
Mine Woods BB is accessed from the top through a hole, maybe yours is older? Here is a screenshot how mine are removed.
Deerherd
Veteran Member
- Joined
- Apr 9, 2012
- Messages
- 1,064
- Location
- Upstate, NY
- Tractor
- LS P7030 CPS, 2016 Bobcat E42, Ferris IS3100z w/37 HP Kawasaki
The cap screw (35) is a standard thread, you have to drive the blade pin out, read the notice about supporting the arm so you don't damage the gear box.
thistledewfarms
New member
Did yours have a blade pin (mushroom head) on both top and bottom? All I need to do is drive that out? Already removed the threaded bolt and the shims.
At this point I was going to just try to take the crossbar off and sharpen the blades all as one.
TMGT
Elite Member
My older m4 should be the same, once the shims and retaining clip is out the pin should come out, however mine required a drift, hammer and air chisel with a drift attachment to get them out.
Oh and a good soaking with PB blaster.
Oh and a good soaking with PB blaster.