cooljoe00
Member
As the title says I just got a NX6010Cab HST tractor and a woods bb72x rotary cutter and both the shaft and the PTO drive shaft have 6 splines but they will not slide together the drive shaft (sleeve/female) end seem just a little to small in diameter to fit over the tractor PTO shaft. Are there differences in Spline Diameter I though all 6 spline were the same? If any other numbers are needed in order to tell the type I have you'll have to tell me what to look for. I am so tired; I tried rotating the tractor PTO shaft, pulling the collar back on the drive shaft to release the bearings after an hr I got sick of holding that pto drive shaft in the air.
Last edited: