FEL Road Maintenance Cutter

[lt190b]

Thanks.

 

[bhstovall]

I really need one of these for the land I just purchased! It is a remarkable piece of engineering, I would like to hear the story behind it. Will definitely go back & read the entire thread when I get time!!!

 

[Duerwood Willis]

Had a little time to kill Sunday afternoon, I have watched my neighbor since hurricane Ivan (2004) try and maintain/reclaim his fence row. He pecks away for hours with little progress so I tried to lend him a had for approximately 20 minutes, this is a time lapse of what else LaneSharkUSA can do.

Lane Shark USA - YouTube

 

[TCJatko]

I'd like to have one.

 

[lt190b]

Great question! The relief valve piece may have been poorly written on my part. That is more around the specs of the motor. For those with hydraulic systems greater than 15gpm we include a Parker Flow Control valve with or without the purchase of hoses. The motor relies on the relief valve of the application.

If operating pressure of the application exceeds 3000 psi an aftermarket divert/relief valve will need to be purchased separately. We will and can custom match a hydraulic motor for your machine at the actual cost of equipment.

Duerwood, what hydraulic motor would be a match for an auxiliary standard flow of 20gpm and 3000psi on an excavator and a ctl with 20.8gpm and 2600psi, maybe one motor for both? Here is the reason for my question.

 

[lt190b]

Anyone else have a suggestion?

 

[Duerwood Willis]

I do have a larger motor that should be a direct bolt in! I'll get you some info tonight, looks good on the mini.

 

[lt190b]

I do have a larger motor that should be a direct bolt in! I'll get you some info tonight, looks good on the mini.

Any news?

 

[Duerwood Willis]

Any news?

Char-Lynn 101-1750-009, 15GPM and about 500 RPM's slower. $354

 

[lt190b]

Duerwood, thanks for the information. Have you used this motor on any cutters? Does the lower rpm have a negative effect on cutting? Is it 50 rpm or 500rpm?