What have you done with/to your GC Series 2300, 2400, 1700 Tractor TODAY

[Dmacleo]

going in tomorrow to pay for blizzard (rad tek) 54" rear mounted manual control (no backhoe no rear circuits) snow blower.
due to health reasons had to turn plow truck and brand new boss 9.2 dxt over to another driver that lives 35 miles away so...got to clear driveway and private road somehow.

 

[GeneV]

Oooh, sorry to hear about the health issues, man.

Well me, we finally got some snow here, not much, 2.5" of wet/heavy stuff. So, hooked the plow onto miss fergie, and off we went.

 

[cglaser104]

I started my double clamp grapple project last night. Starting with making up a prototype out of some old 3/16" paneling to make sure the geometry works out. I'll rip some scrap 2x4's to take the place of any cross member that id use.

 

[GeneV]

It's gonna be used with the bucket?

 

[cglaser104]

It's gonna be used with the bucket?

No. I like the curl and dump angles of the bucket so I'm matching to that angle. I considered everything from 90° to the ground to 65° to the ground and everything in between. I was making sure my template tine matches the bucket angles in that shot

 

[GeneV]

No. I like the curl and dump angles of the bucket so I'm matching to that angle. I considered everything from 90° to the ground to 65° to the ground and everything in between. I was making sure my template tine matches the bucket angles in that shot

Looking forward to watching this build, man!

 

[MoMower]

Photo dump from the last few months. Complete landscape tear out, driveway approach angle fix/parking area, 2 acre tilling job.

 

[MoMower]

 

[MoMower]

Shed pad, trough drain, driveway and parking area, trench and a new tow buggy!

 

[MoMower]

Also managed to break two hoses at the connections, BH curl and outrigger raise, within a week of each other….and so it goes…