weld shop clean out job and other Keweenaw sites

[ArlyA]

I was in the old shop today to run my battery charger and snapped a few pics for you characters.
Here is the bench top mill I've wanted!

 

[ArlyA]

A good used lathe FS. Yes everything here is.

 

[5030]

I'll take it on one condition, you deliver it. I can unload it too. Have 2 15 ton Hysters.

I'll take the radial drill as well. The W&S and the drill would be a good semi load.

I presume it's 440/3 correct?

 

[BravoXray]

2 hp motor?

 

[2manyrocks]

I was in the old shop today to run my battery charger and snapped a few pics for you characters.
Here is the bench top mill I've wanted! View attachment 755248View attachment 755249

There's still metal shavings on the equipment. It's like walking into a time capsule. Almost beyond belief that whoever owned this business didn't try to liquidate the equipment? Or the current owner bought everything but isn't in the metal working industry themselves?

 

[ArlyA]

2 hp motor?

Ha! You are waaaaaaay low Dennis. Another I seen in the shop. (HP is not 50)

 

[5030]

I was in the old shop today to run my battery charger and snapped a few pics for you characters.
Here is the bench top mill I've wanted! View attachment 755248View attachment 755249

That is a radial drill, not a mill.

 

[5030]

Ha! You are waaaaaaay low Dennis. Another I seen in the shop. (HP is not 50)View attachment 755275

Lotta conductor grade copper in that one. You might want to take it home and take it apart.

 

[2manyrocks]

Wonder what it weighs?

 

[ArlyA]

Wonder what it weighs?

I'd guess 400lbs give or take. The motor I asked about is 37HP. I've got more pics I'll post when time allows.