bcoving
New member
The pins are stuck on my quick detach for the bucket. Does anyone have a tip to get them loose. Trying to put my grapple back on. Never had this problem before.
quick release bucket
- Thread starter bcoving
- Start date
- Views: 1847
nvmyhd
Silver Member
I've had to tap the side of the pin before with a hammer.
Maxify55
Gold Member
It happens with my 3037 from time to time. I just keep a box wrench in the cab for when it gets finicky. Loosen the bolt and the pin slides right in.
Then, you figure out that if you pull the handle too far in opening, THAT'S when it jams. Just don't go ripping at the handles. It'll work just fine.
I think I caught my left on in the up position, once picking up my pallet forks and bent it pretty severely. I just pounded it back straight.
Little did I know that it would hamper the closure of the pin into the various attachments.
Bought another handle. Just haven't installed it yet.
It's on the list, though.:laughing:
For about a year now. I think?
I'll get around to it. It just hasn't ticked me off enough yet.
know that it sould hamper the action of the piston
Then, you figure out that if you pull the handle too far in opening, THAT'S when it jams. Just don't go ripping at the handles. It'll work just fine.
I think I caught my left on in the up position, once picking up my pallet forks and bent it pretty severely. I just pounded it back straight.
Little did I know that it would hamper the closure of the pin into the various attachments.
Bought another handle. Just haven't installed it yet.
It's on the list, though.:laughing:
For about a year now. I think?
I'll get around to it. It just hasn't ticked me off enough yet.
know that it sould hamper the action of the piston
