I got a new roll pin from a local dealer. If you don’t have an LS dealer, the new holland work master 25s has identical part numbers. That one has since broke as well so I’ve put a temp bolt in place until I can get a new pin in.
My weld finally broke so I was back at the replacement search. Turns out, these are breaking at a pretty good rate. They now have a part number to replace just the rod end. 40433226. If you’re in a pinch, you can pull one off the backhoe control. It’s a little at too tall but it will get you out...
I noticed a dramatic drop off of top end speeds in forward and reverse lately so I thought maybe the linkage was due for some adjustment. Everything was tight BUT pedal stroke was not translating into valve motion. The pedals had positive return and moved proportional to each other but there was...
It was my fault. Felt a roll and had the lever in hand and panicked. Put a good bit of force on it. One of the rod ends for the control valve snapped. It痴 a control lever, not a 徹h s#!+ handle. Lesson learned. Now to find this part. Dealer only specs whole assembly. Any ideas??
Just got hold of my new 125 and was browsing the operators manual for the loader. Mine came with the LB1101, which I assume is a new model since on page 32 of the manual it lists an optional Quick Attach Asseymbly and Dual Bucket Assembly! These are not in the manual for the LB1100. I'll figure...
First post Newb here. My search is almost over for a new SCUT. Does anyone have time to throw a quick tape measure on their MT125 in the TLB configuration? I致e found every dimension I need except this one! Thanks in advance. This place is awesome.
-Aaron
Future MT125 owner