Recent content by AllByteNoBark

We put up a bat house 2 1/2 years ago and all we had for residence were wasp. I checked it about a month ago and nothing but the wasp nest. Last night I was setting on the patio and saw we had occupants. So tonight the wife and I went out to the shooting bench that is near the pole holding the...

Got another truck load of crushed limestone this morning. Had some time this afternoon so got it spread. Biggest load I have had, 27.32 ton. Glad as it was just enough to finish the drive. Finally got it pretty well figured out by the time I was done. :laughing: Made the wife happy which is...

Hunt, we must have seen the same bench plans online. Son and I built two of them one for 100 yard and one for 200/300 yard. Good solid design. The plywood sounds like a good idea but, like you, I don't like plywood outside. So far ours have served us well.

Well, seems I have been super busy for several months. Finally got around to putting a little gravel on our turn-around. I've decided I am not to good at spreading gravel but it is still better than it was. The base is pretty good but needed topped up. Here is an image of the before and the semi...

Lower stuff all looks real close

That area looks pretty good I think

I think I see the difference. On mine the lever the rod attached to is straight up and down. Yours is leaning back.

Here is one at the same angle.

Like these?

Someone mentioned the placement of the welded but. Here is that.

Here it is.

Whoops sent the same one twice here is the other one

Yep, here you go.

Here is what mine looks like when the bucket is level. I have the 72 in flat back bucket. Let me know if you want me to measure anything.

Can anyone tell me if box blade shanks with rear slots will work on a box blade that came with shanks with front slots? Having trouble finding reasonable priced shanks.