Recent content by awhite

I'm in the process of replacing the rubber springs on our Allis Chalmers planter. Just wondering if anyone else has had any experience doing this. There seems to be a pin that needs to be removed to seperate the rubber spring part from the coulter frame. I've found a parts blowout from Agco...

We've got a Ford 3930 MFWA that seems to be leaking engine oil from the back of the oil pan. I figured it probably needs a new gasket. We just recently acquired this tractor about a year ago. It's got around ~600 hours but has spent most of it's life outside. Replacing the gasket seems...

We've got a Kubota M6800 with a dry clutch which we had to replace last winter. It has been working fine until about a couple of weeks ago. Now when "shuttling" between F/R, there's a grinding noise when trying to go into R. The clutch is adjusted within specs. Not sure if there's a sync...

Thought I'd share this for all the Bush Hog loader owner's out there... I recently purchased a set grapples to use to clean up some burnt brush piles. As I was shopping around, I was tossing around the idea as to what kind of quick connect system to get on them. We have a M8560 that has a...

Got a 2004 Kubota M6800 MFWD with ~1500 hrs. My dad was using it Friday and had it off and on while working. Got back on it to crank it up and it wouldn't start. I've trouble shot the glow plug relay and starter relay according to the service manual and also replaced the key stop relay. I've...

Have a G&S DM206 disc mower. Was wanting to know if anyone would know where to buy parts for it or a parts book. Have had it for about 10 years and it has really been a good machine, but it's starting to wear out. Any info appreciated.

Wanting to know where to buy parts online for a Maschio FBR 160?

Kubota M6800 4x4 hydraulics are overheating! Seems to work fine when cold, but after running for several hours, it seems that the hydraulics get extremely hot and the pressure decreases on the hydraulic system. Also the rear end gets so hot that you could literally fry an egg on it. Tractor...

Recently I've noticed that the hydraulics on my M6800 are slow to respond after the tractor gets warm. It has a Bushog loader, and you can't get the loader to respond unless you run high rpm's. Replaced hydraulic fluid and filter less than 50 hrs ago. The old hydraulic fluid looked milky as if...

Kubota L3830 won't run more than 5 minutes. Sounds like some kind of safety feature is making fuel solenoid shut tractor off. Bypassed seat and PTO and still have the same problem. Replaced fuel solenoid and still have the same problem. I think I have the problem narrowed down to either the key...