Recent content by azrancher

I don't know the brand of cement mixer, bought it from a company back in the mid 90's (Farm & Family?) now out of business. I need a new seal for the dump cylinder, single acting cylinder, 1.75" in diameter, about 18" long has a stamped part number on it B-2-3-SAI07514. Any suggestions...

1973 580B, I've had this Backhoe for about 20 years so I know how fast it is running just by sound, however the tachometer has now decided to read excessively high, and I think it's a mechanical tach, so I don't understand what is going on, and it varies, sometimes it appears to be reading...

OK I got a MF30 industrial tractor, AD4-203 Perkins engine. The fuel fittings have a 1/4" flared steel tube, with a rubber "gromet" next with the nut next, see rough pic for the gromet. All the auto parts stores have come up with zero, where do I get these guys, I did use 2 A/C washers to...

Yes 3 bolts hold the pump to the drive gear, 3 nuts hold the pump to the drive casing on 3 studs. The pump has 3 holes that are slots that can be used for timing the pump, I just installed it back close to what it had been.

OK, my MF35 is making so much oil that I have narrowed it down to the Injector pump, I first replaced the fuel pump, but oil/fuel is pouring out of the dipstick hole at around a cupfull per minute. So I don't think it is blowing by the rings at that rate because it is running just fine. My...