Cleaned all the fuses .....not knowing which one might be the correct one.....but that did not help. Then looked at all the fuses to see if any were blown......lower 15 amp was blown. I then replaced said 15 amp fuse and the tractor now shuts down! Thanks for the info!
You have a $150K tractor but don't have a barn/shop/garage? $500 labor to install a battery? Wow. I am impressed! I should have gone into a different business.
Finally go t it. It was a spring loaded pin in a hole on the side but was just very stubborn and didn't want to come out. I pushed the spring loaded pin and pulled very hard on the knob. High beams working and tomorrow the low beams and the horn. Thanks for the advice.
I am trying to get a Cushman 3 wheeled Turf Truckster running and bought a switch to hook up the horn and headlights which the unit has but the horn button was gone and the headlight switch frozen. Sooooo....I bought one of these and I can't get the knob off to install in the dash. It is a...
Dennis,
Thanks for the info. I will need to read through it a few times more but it looks to be what I was thinking. I will need to repair/replace the broken parts (31) on the drawing on figure 2-43 from your attachment. I have been out of town and the repair has been on hold but I need it...
Anybody have any idea how this thing works. I am thinking that the position of the lever sets the lift in motion and the movement of the lift arm moves #3 (feed back arm) and stops the lift when it hits the correct (set by lever) level.....????? Ideas?
dlctcg
Thanks for the response and the info. I could not find anyone that sold parts for this tractor and it is my first repair on it for a friend. He said the lift lever had been pretty hard to operate for a long time.
Any idea what's inside the case connected to this arm? I have tried...
1) I removed the "E" -clip from the lever pivot and cleaned and lubed the shaft and it moves freely now.
2) I removed the control assembly and cleaned and lubed both ends and it now moves freely.
3) The bracket to attach the 3 point hitch lift arm to the feedback arm (my term, not sure what it...
I have a TC-25 New Holland tractor about 1995-1995 model. The 3 point hitch has been hard to operate for awhile now and drops on its own sometimes. I pulled the wheel off the right rear and pulled the cover from the lift handle assembly and found 1) very tight bushing on lift assembly...2)...
Hey Folks,
I am having to rebuild my FEL bucket on my Kubota L35. I have purchased a new weld on blade/edge from Kubota but will need to replace the bottom of the bucket and the back up a few inches from the turn where it starts up. I have graded with it for 19 years now and have worn out the...
I have a 1975 Cub Cadet 1000 tractor with a bad engine (Kohler 10 hp cast iron). I also have a D600 Kubota engine which I am considering installing into the Cub. My question is this: The D600 currently has several pumps attatched since it was origionally installed in a Jacobson Turf Mower and...