Recent content by bctxprop

I took recommendations from y'all and had FitRite help me out. Awesome job and these are much better than the Pat's IMO...

(y) Turned out good. I just wired directly. Might need to adjust front camera but happy with it.

I contacted the dealer to confirm and inspected it myself as well. The ACC fuse, labeled 'Accessories,' powers both the cigarette lighter and the radio. The CABIN fuse, labeled 'External Power Supply,' doesn’t appear to be connected to anything. According to the dealer, it’s likely for the...

I’ll get an adapter for this. Thanks for confirming everything. However, I need to verify a couple of things: The 'ACC' fuse is labeled 'Accessories' but doesn't specify in the manual what it is, and I believe the 'External Power Supply' fuse is for the cigarette lighter. I don't have an outlet...

Thanks for that, Willy. Here's the diagram that came with the system. Also, attached is the fuse/amps diagram for the YT359. Looks like it's a 10AMP fuse. I'm guessing the ACC fuse is the cigarette lighter as it says not to use as such but for accessories only. It's the only extra power outlet...

This question has probably been asked before, so I apologize in advance for any redundancy. I recently sold my old tractor and now have a new 2024 YT359C. I’ve installed the radio and some other accessories, and I’m considering adding a camera at the back and one at the front for loader work...

Well, FWIW that piece of wood was pretty straight. I tested with my level, too. Does Milwaukee brand suffice?

I was curious, took the designs off their website and asked a huge machine shop in Texas that does industrial work how much they'd charge to make something that looks as nice as the EA version. Well, they charge $150/hr and said 5-6 hours (engineering plus production) so obviously not worth it...

so what's the solution? Should I return it and would this be considered a manufactures defect?

77" Cut Heavy Duty Hydraulic Offset Flail Mower, FH-EFGCH195KIT | Betstco Sales, Parts, and Service: min HP is 35 and I'm running a 60hp tractor. Obviously my PTO hp is less (52 I think). I'm mowing between 1.5-2.5 mph so don't see how going slower is going to help. You can see how much I was...

It's the belts that come from Betstco. They come in a set but not sure if it's a matched set. The tension seems the same on all the belts. At $75 for four belts and with them burning up every time I run the mower at some point we're going to have to toss in the towel. I'm already $150 out on belts.

That's what several farmers in the area said after seeing the belts. Something isn't right with the pulleys or something... It's not the bearings because everything sounds good and turns. The belts aren't too tight or too lose.

They're not engaging the ground. This is South Texas and it's mostly flat with no rocks and was cutting weeds/grass, nothing crazy. Tractor speed was 1.5-2.5 mph depending on areas cutting. Happy to show you the grass it was cutting, nothing exciting. We have goats, sheep, and everything else...

The belts aren't over-tightened. My neighbor, who is an Ag mechanic, and my father-in-law, who was a cotton farmer for over 30 years, both checked the belts after I replaced them. They said the belts were as specified and didn't seem too tight or too loose. We even ran the implement for a bit...

Yes, lower pulley spins freely. The hammers are installed the right way and were installed by Betstco.