bjmsam's latest activity

I tried again this morning with a 5# short-handled sledge hammer. The leverage rod went through just fine. Took about two licks on the...

I forgot to throw this in and its kinda after the fact because you already bought the 3710 but-- The 5030 I have has the new style...

</font><font color="blueclass=small">( $5,000 is a lot of cash, might be a good idea to take a closer look at the used model? )</font>...

Well, lets see, I owned a L3710 before I traded it on a 5030. The 3710 has around 32 pto horsepower with the HST. The dash is analog...

I never took the loader off of my previous L3410. The side panels pop out an inch, then are slid up and off the tractor. Perhaps the...

The upper side covers slip right off by lifting up and over the FEL. The lower covers attach with 4 screws each. There should be no...

It will be much easier if you remove the loader and it's a good idea to be familiar with the process anyways. Doing things like changing...

I got my cylinder back. The cost of rebuilding it was about $220. The bill says I paid $20 for freight, although I carried it in...

Here are a couple of quick shots that might help. One shows the hole I drilled. I measured 1" back from the edge of the plate to center...

I have some unfortunate corrections to make to the post I made about getting the steering cylinder out. I thought there was only one...

I am at the point where I can get the cylinder out. I will post what I did in case anyone else has this problem. Leave the loader in...

I had a L3710 I traded for a L5740 when I retired, to get a cab. I didn’t replace implements I had specific for the L3710. The L3710 was...

I've had an L3710 for 25 years, all my implements are 72" or bigger, with no issues. It is HST with a 72" FEL. I use a 72" tiller in...

I still use mine. In fact, it spent most of it's life mounted on the back end of my LOADER TRACTOR ;) They're handy for a few things...

SOLD