Recent content by bones66

I watched a post recently where a recommended service to a Kubota diesel was to clean the muffler. Supposedly described in the manual.

I recently installed a new engine block heater. The new heater was a different brand than the old one. My old one had served me well (over 40 years) and decided to call it quits. Although I don稚 use it that often. When I installed the new heater which was a different brand I flushed and changed...

If the tractor pto has 6 splines and it is a 1 3/8 can I assume the other end of the shaft which fastens to the Bushhog gearbox and has 6 splines is also 1 3/8?

When I am operating my bush hog and using a chain instead of a top link should the chain be tight, have slack. If you say slack about how much. Please do not try to save my life by telling me how dangerous using a chain is.... I already know it is not OSHA approved! Thanks!

Posting for a friend so sorry I cannot give to the loader model number right now. The front end loader bucket is not quick disconnect. Can it be converted to a quick disconnect system without cutting and welding. This is a Kubota M series tractor

For those interested. 1 picture is of tractor side the other is of implement side.

Hearing a clicking noise coming from my Bush Hog as I am shutting down and the blade rotation slowing I thought maybe I had a u-joint going out. However it appears the slip joint is loose. How are they measured to tell if they are worn to the point of replacement.

I致e got an old Bush Hog (brand). It痴 an older model 12. After a recent drain and change of lube I was looking at the filler plug and it has two small holes in it. I知 assuming the holes are a pressure release. The plug sets at a 45ｰ angle in the gear box so I assume I just put the holes towards...

A friend has an old 8N that hasn稚 run in nearly 15 years. A friend of his offered to help him get it running. This tractor has been converted from 6 to 12 volts and the engine was rebuilt some years back. I thought an 8N was positive ground and commented to that as he put the battery on and...

where might I look to find a set of ROP痴 for a 78 Massey Ferguson.

i'm not sure my point is being understood or i'm not understanding the responses. I do have the proper Pat's Easy Hitch which is Cat 1. I think the best thing for me to do is figure out how to post pictures on this forum and see what happens. Thanks to All! I think I've got it. If I align...

Has anyone tried one of these PEH on a Massey Ferguson MF-230 diesel? It says it will work on lift arms from 2?3 1/4? Not sure where this measurement is taken but my old MF might be a bit shy of the 2 needed. I think the 230-245 are the same but not 100% on that. Anybody know for sure or have...

I had my tractor weight bar welded recently as the strain over the years had began to take it's toll. To keep the welded areas from rusting I planned to brush on some Rustoleum primer followed by a coat or two flat black Rustoleum paint. Then after I applying the primer I remembered having a...

A couple of years ago I replaced the fuel tank on a diesel MF-230. MF no longer made the tank so an aftermarket tank was the only option. The tank was identical in size and shape to the old one as far as I could see. The only difference being the new one had the fuel return line in the front...

I have an older 3 cyl Massey Ferguson with a Perkins diesel engine. It has a CAV injection pump that is dripping diesel fuel from the large nut that comes out of the bottom of the pump. The nut itself is about 2" long so it's not just a nut and serves some other purpose. I think this would be at...