boomer1025's latest activity
-
Bboomer1025 reacted to Santa Craig Cringle's post in the thread What piece of equipment or attachment do I need? with
Good Post.
I’m guessing a tracked skid steer would be preferred? -
Bboomer1025 reacted to SPYDERLK's post in the thread Grease - is there no better way? Can we talk about this? with Good Post.
Clothe your grease gun in an old cotton sock. Change as needed.
-
Bboomer1025 reacted to Runner's post in the thread Grease - is there no better way? Can we talk about this? with Good Post.
Here's a method that helps me: Before I insert the new grease tube into the gun, I reach into the "bottom" end of the tube and get a...
-
Bboomer1025 reacted to paulsharvey's post in the thread Help me decide, 3 trucks I need to pick 1 from. with Good Post.
Far be it for me to not spend you money... But, even if you put $10k into repairs, refurb, and updates on the 7.3L you already have...
-
BLooks like the shaft is bent to me. The connection at tractor doesn't seem to spin well. JM2C.
-
B#1 - I'm not a real welder. I'm a hobbyist. I'd suggest a dual voltage welder. I started welding on the in-law's farm in the 70's...
-
Bboomer1025 reacted to 5030's post in the thread Push over trees with a small compact? with Good Post.
I don't believe ANY small tractor has the Cajonies to push over any tree except maybe a dead stick. Grinding the stump is so much easier...
-
Bboomer1025 reacted to Roadworthy's post in the thread Yanmar SA424 fuel gauge flashing with Good Post.
Check the manual for possibilities or ask your dealer. Is a low fuel indicator light flashing? Is the needle swing back and forth? I...
-
Bboomer1025 reacted to pmsmechanic's post in the thread Pickup fuel pump replacement - lifting bed with Good Post.
I've done this several times. Measure carefully and cut a hole in the bottom of the box. I used a zip cut blade on an angle grinder...
-
BI've run the gambit on both sides of this equation. When I had my lawn service I kept at least 3 sets of blades at all times. I would...
-
Bboomer1025 reacted to joecdeere's post in the thread old 4300 pulling even older brush cutter - better alternative? with Good Post.
What range are you trying to climb and mow in?, sounds like you’ve got it in too high of a choice
-
Bboomer1025 reacted to groundcover's post in the thread a good old fashioned electrical fire with Good Post.
Sounds like this could be a runner up for the why women live longer then men thread !
-
Bboomer1025 reacted to oldnslo's post in the thread LS xj2025 will start, but when I let go of key, the tractor dies. with Good Post.
Presuming this is a diesel does the fuel shut off solenoid have two or three wires? If two wires one should have power with key in the...
-
Bboomer1025 reacted to oosik's post in the thread Let my neighbor borrow my tractor... with Good Post.
Fortunately - all my neighbors, that need tractors, have their own. Those who do not - I would hesitate to loan them my heavy duty pry...
-
BCattle will scarf it down, but I don’t particularly like feeding hot/moldy hay to anything.