Recent content by Brian2665

My 2665 grinds a little when going into gear and a little worse as it warms up. I do know the pressure plate is not releasing all the way and the clutch adjustment is good. It does not slip and is still under power train warranty but my local dealer says they won’t cover it and adjusted it so...

They would not warranty it

They are casting frames when I pick it up I will takes pictures

Check your fuel lines at the filter they crack enough to suck air and not notice a leak. Wiggle the lines around when running you will see the leak. That happened to me easy fix

This is my 3rd mahindra upgrade my first one was a 2515 and put a 1000 hours on it then i bought a 4035 and put 800 hours on that as well. My 2665 has 600 hours on it. I’ve used these all the same even if I use close to 3000lbs a lot the frame should never give.at that point they might as well...

Tires are loaded and use box scraper for weight. I just had the frame replaced but they saved my old one.as soon as I get it I will take pictures and show how that there is a weak point in the design in the casting.

I have a 2665 that the axle support frame cracked. I took it to the local dealer and they contacted mahindra and they said it was from abuse. This thing looks like new and has not been beat. I’m the only one that operates it. It’s sad to have a warranty and they won’t stand by it. It is tym...

I just purchased a new 2665 cab and was looking on some feed back about this unit. I looked around and don’t seem to see anybody around owning one.

I just purchased a 2018 Mahindra 2665 cab. I’ve been all over this forum and can’t find any feed back on this particular model. I don’t know if this is good or bad. I traded my 4035 in for this cause of the winter use and let’s face it a/c is nice. Just looking for some good info on this new unit.